Nice that you visit our site. Please indicate here which cookies we may place. The necessary cookies do not collect personal data. The other cookies help us to improve the site and your visitor experience. They also help us to inform you about our products. Are you going for an optimally working website including all the benefits? Then tick all the boxes!
Make sure you have completely cleaned your work table before you start the replacement. In particular, avoid the presence of metals (dirt). Place the tweeter on the back, the horn of the tweeter (throat) is usually fixed with screws at the front. Loosen them.
Bullet tweeter - horn removed
The horn of the tweeter has been removed, the frame of the diaphragm (1), the moving part of the diaphragm (2) and the bullet (3) is visible.
The bullet must now be removed. It is usually fixed with a screw that protrudes through the magnet, but is sometimes inserted into the hole of the diaphragm. Turn the bullet counterclockwise. If necessary (and if present... not always the case...), unscrew the screw at the back of the magnet at the same time.
Bullet tweeter - bullet removed
The bullet is loosened and the diaphragm can be removed. Visible are the frame of the diaphragm (1), the ring of the diaphragm held by the bullet (2) and the screw of the bullet (3).
Replace the diaphragm after cleaning the magnet gap
Gently lift the diaphragm and remove it from the magnet (1). Also visible are the screw of the bullet (2) and the diaphragm (3).
Before placing a new aperture, first make sure the air gap (4) in which the diaphragm coil was located is cleaned. Clean with some tape, or take a look here. top.