Welcome! This website uses cookies.

Nice that you visit our site. Please indicate here which cookies we may place. The necessary cookies do not collect personal data. The other cookies help us to improve the site and your visitor experience. They also help us to inform you about our products. Are you going for an optimally working website including all the benefits? Then tick all the boxes!
Home     Glue for speaker repair - 50 cc, frost-free packed
Glue for speaker repair - 50 cc, frost-free packed

Glue for speaker repair - 50 cc, frost-free packed

This adhesive comes with a brush and seperate dosing cap. Packed in insulating material.

This is water-based glue. Do you have a mailbox on the road (outside your home), and there's very cold winter weather, the adhesive may freeze. After freezing, the adhesive has become unusable. This glue is packed in aluminum foil and then in bubble film and would normally not be able to freeze. Due to this packaging, the adhesive must be sent as a parcel.

Shelf life: up to 3 months.

Special water-based, permanent-flexible adhesive for speaker repair. This bottle contains 50 cc glue.

This glue is suitable for:

  • Gluing foam surrounds to a speaker cone / frame
  • Gluing rubber surrounds to speaker cone / frame
  • Gluing fabric surrounds to speaker cone / frame
  • Gluing dust-caps to a speaker cone
  • Gluing gaskets

This glue is not suitable for gluing spiders and voice coils.

This is a water based adhesive. Keep the adhesive in a frost-free room.

Surface must be flat, dry, and free dust and grease. Apply the glue with brush or roller. The Elastic adhesive dries relatively quickly. If thicker layers are applied, or the adhesive is used with less porous materials , the drying time will be significantly longer. The glue is dry when the color is transparent and the original white is gone. The adhesive can be applied both single- and double-sided. For a higher final strength and longer drying / processing time we recommend to apply the glue doublesided. Remove wet glue immediately with a wet cloth, dried adhesive residue can be removed mechanically. Clean tools immediately after use with water.

Base: acrylic dispersion
Solids content: about 60%
Density: approximately 1 g / cm ³
Viscosity about 5000 mPa's
25 °C pH value: 5.5
Min. processing temperature (MFT): 10 ° C
Wet color: white
Dry color: transparent
Odor: odorless (slightly acidic)
Number of components: 1
Temperature resistance (dried): -40 ° C to +160 ° C
Moisture resistance: good (if applied doublesided)
Open time: infinite - lasting tack
Drying time: Depending on the circumstances of 30 minutes to 2 hours.
Consumption: 250 g / m²

Safety sheet
In case of problems the safety sheet is available here (Dutch language).

€ 9.29

Article code: Lijm50KwastVorst